Effects of electrical parameters and their interactions on plasma electrolytic oxidation coatings on aluminum substrates

Based on orthogonal experiments, the effects of voltage, frequency, duty ratio and their interactions on the thickness and corrosion resistance of coatings prepared by plasma electrolytic oxidation (PEO) on aluminum in an alkaline silicate-containing electrolyte were investigated. The thicknesses of these coatings were obtained by measuring their cross-section using Image J software. Their corrosion resistances were evaluated in HCl and NaCl media through spot test and electrochemical test. The results show that the experimental design of this study is the key to investigate the interactions among these electrical parameters. Additionally, not only each independent factor, but also their interactions exhibit a remarkable influence on the coatings. The combination of high voltage, low frequency and large duty ratio significantly increases the coating thickness and content of the corrosion resistance phase, and thus improves the corrosion resistance of the coating in HNO₃ medium. Conversely, the coating possessing the densest microstructure and best corrosion resistance in NaCl medium is obtained when low voltage and high frequency match with a small duty ratio.     

射频法原油含水率频率参数优化

根据电磁场相关理论研究、水和油两种介质的介电常数差异性较大以及在不同频率下含水率的特性来进行参数优化与设计,选择最优参数来提高含水率测量范围。对不同频率测量下含水率测量的大量实验,可以得出在含水率0%～100%范围内测量下,20MHz频率下幅度的曲线线性度较好,实现参数优化与设计。     

基于功频下垂控制的光伏并网发电系统惯量阻尼机理研究

针对光伏以低惯量、弱阻尼的特征大规模接入电网，给电网稳定性带来不利影响的问题，基于功频下垂控制的光伏并网发电系统，借鉴经典电气转矩分析法，从物理机制层面上分析影响系统惯量、阻尼以及同步能力的作用规律。研究结果表明对于控制参数的影响规律而言，惯量特性主要受功率环的比例系数Kp影响，且随Kp的增大而增强；阻尼特性受频率下垂系数Dp影响比较明显，且随Dp的增大而减弱；同步特性只受功率环的比例积分系数Ki影响，且随Ki的增大而增强。通过仿真验证了理论分析的正确性。     

应用PMO提高连铸坯生产拉速及成分均匀性

为了实现电炉厂提产增效的目标,研究了脉冲磁致振荡(PMO)在提高铸坯生产拉速中的应用潜能。结果表明,优化PMO处理参数可以适应生产拉速提高的要求,并改善铸坯的中心偏析和宏观偏析。当连铸拉速提至1.05 m/min,PMO脉冲频率为1.16K_f Hz,峰值电压为1.00K_iV处理参数(K_f和K_i分别为仪器的放电频率和电压峰值)时, 铸坯横断面碳偏析指数可控制在1±0.05内;当连铸拉速提至1.15 m/min,PMO脉冲频率为1.28K_fHz,峰值电压为1.00K_iV处理参数时,铸坯横断面碳偏析指数可控制在1±0.07内。试验证明,在高拉速条件下通过保证单位时间内对钢液施加的脉冲能量可以使连铸坯质量得到有效改善。     

采用高频等离子技术制备球形陶瓷粉末

采用高频感应等离子球化工艺生产的预合金化空心球粉末,综合了喷雾干燥法及熔融-粉碎法粉末两者的优点。与其它类型陶瓷粉末相比,预合金化空心球粉末还具有以下优点:高沉积效率、更均一的熔化特性、重复性良好,是一种更为优良的喷涂粉末材料。     

一种射频抗电磁干扰的矿用红外温度传感器

设计了一种适用于复杂条件下实施井下温度探测的射频式红外温度传感器。借助于光学系统、光电探测器实时感应井下温度并提取温度信号,同时在DC-DC电源隔离模块中实施EMI滤波以抗电磁干扰,处理后的信号经过A/D转换、运算器放大后显示在LCD上,实施读取数据并记录在传感器的存储片上,实现了矿井复合灾害条件下的温度测试,测试精度控制在±2%。     

Luminescence modulation of the Eu3+ doped Srn+1SnnO3n+1 (n=1, 2, 5, ∞) ceramics based on photochromism and its application in anti-counterfeiting technology

The structure and optical properties of Sr_n+1Sn_nO_3n+1 ceramics greatly depend on the n value. Thus, we fabricated four compositions, namely Sr_n+1Sn_nO_3n+1:Eu³⁺ (n = 1, 2, 5, ∞) ceramics, and their crystal structure, photoluminescence, photochromism and luminesce modulation properties have been investigated. It is found that excellent photochromism and luminesce modulation properties are found in Sr₂SnO₄:Eu³⁺ and Sr₃Sn₂O₇:Eu³⁺ ceramics. After 280-nm light irradiation, the Sr₂SnO₄:Eu³⁺ ceramics transform into gray purple from primal white. Meanwhile, luminescence intensity decrement ratio ΔI_dec of the colored Sr₂SnO₄:Eu³⁺ reaches a high value of 80.8% under optimized irradiation wavelength. The decreased luminescence intensity of Eu³⁺ can be completely recovered via 450-nm light irradiation. The ΔI_dec of Sr₃Sn₂O₇:Eu³⁺ ceramic reaches 53.1%, and the decreased luminesce intensity can not be covered by light irradiation, only can be covered by a high temperature stimulus at 400 °C. Finally, we successfully fabricated a flexible membrane using Sr₂SnO₄:Eu³⁺ and PDMS for anti-counterfeiting applications.     

Low Frequency Electromagnetic Casting of 2195 Aluminum-Lithium Alloy and Its Effects on Microstructure and Mechanical Properties

In this study,the low frequency electromagnetic casting(LFEC) technology was adopted to fabricate 2195 Al-Li alloy.The microstructure and solid solubility of as-cast 2195 alloys,as well as the second phase precipitation and tensile properties after aging,were investiagated and compared with the counterpart direct chill casting 2195 alloy.Our results indicate that LFEC can significantly improve the microstructure and metallurgical quality of as-cast alloy,and increase the number density of θ'(Al_2 Cu) and T_1(Al_2 CuLi) phases during aging treatment due to the enhanced solubilities of alloying elements.The tensile properties of 2195 aged alloy cast by LFEC were hence improved evidently.     

部分传输序列的遗传模拟退火搜索方法

在正交频分复用(OFDM)系统中,基于遗传算法的部分传输序列(GA-PTS)技术有效地降低了 PTS 的计算复杂度,但在 改进峰值-平均功率比(PAPR)性能方面却并不理想。 为此,提出在遗传算法中嵌入模拟退火(SA)算子从而构造一种混合的遗 传模拟退火(GSA)算法,并把它应用于对 PTS 的最优相位因子进行搜索。 首先,通过对 PTS 相位因子编码形成染色体,采用随 机元素组成的染色体作为遗传算法的初始群体,并评估每个染色体的适应度值。 然后,根据适应度值选择染色体,建立染色体 的变异规则和交叉规则,对群体进行迭代进化。 最后,群体中的染色体利用退火温度进行更新,从而产生出新的下一代种群。 仿真结果说明,与 GA-PTS 方案相比,该方法不仅能降低计算负担,而且能够有效地降低 OFDM 系统 PAPR 值。